French Drain Information, Oklahoma City, Norman, Moore, Edmond, French Drain Repair, French Drain Photos

Posted: July 24, 2020 in DIY Drain Installation, Drain Repair, french drain, French Drain Information
Tags: , , ,

French Drain Installation in Oklahoma City, Norman, Yukon, Mustang, Edmond, Lawton

Oklahoma Drainage and Sprinkler Repair 405 203 9419 — We provide:

    French Drain Installation, Surface Drain Installation, Drainage System Installation

    Sprinkler Repair for all aspects of Residential Sprinkler Systems

    Emergency Sprinkler Repair Service, AFTER HOURS AND WEEKENDS.

A good place for a French Drain

A Channel Drain Across the, soon to be installed driveway would be a good idea too!

channel drain driveway

Channel Drain set in Driveway

FRENCH DRAIN  CONNECTED TO GUTTERS

Many different types of Drains can be hooked together by one Drain Pipe.  The Drain Pipe then running to an Exit Point makes up a Drainage System.  One common type of Drain used in a Drainage System is A “French Drain.”  Many times a French Drain is installed close to a building foundation or in a low area next to a home or business.  This puts the French Drain in close proximity to Gutter Down Spouts.  Rather than have water come off the roof and out the Down Spout and on to the ground below, many times it is much better to tie a Gutter Down Spout Directly into a French Drain or near by Drain Pipe depending on the Drainage System Design.   Connecting The Down Spouts Directly into a French Drain is much  more efficient and causes suction to occur in the French Drain.  Connection of Gutter Down Spouts to a French Drain makes the Drainage System work better.

 

 

French Drain Before gravel is installedDrainage Systems can:

1.  Keep water away from foundations — A French Drain is best because it can move Surface Water and Sub-Surface Water (water moving under ground) away from the foundation.  Many times less experienced companies install Surface Drains to keep water away from foundations.  This can be a big mistake.  A Surface Drain can’t move or drain Sub-Surface Water.   Also A Surface Drain often can’t move enough water fast enough and easily becomes overwhelmed during a heavy rain.  A Surface Drain also can’t cover or protect a broad enough area. Surface Drains should be designed in a Drainage System to be located in smaller Drainage Areas moving moderate amounts of water.  Surface Drains look better than French Drains.  If ,”appearance” is more important than Drainage Capacity, Go with the Surface Drain.  Just know what you are getting into and what your expectations should be. One side of a foundation alone,  can be over 100 feet.  A 4 inch or 6 inch French Drain is best when protecting a large area such as a foundation.

Surface Drain Installed next to sidewalk in Oklahoma City.

Surface Drain along sidewalk

Surface Drain Installed next to sidewalk in Oklahoma City.

2.  Keep water away from small or enclosed areas.  This might be a low area just through a gate on the side of a house, or the low area between a flowerbed and the wall of a house, or standing water on or near a sidewalk or driveway.  These types of Drainage Problems are best served with Surface Drains.  A Surface Drain can move water away from a low area that is relatively small.  This can occur in yards, flowerbeds, sidewalks and driveways.  A Surface Drain is designed to move Surface Water away from a problem area to a predetermined exit point.  Surface Drains are available in many sizes.  How quickly they remove standing water is usually determined by the size of the Drain Pipe that is connected to the Drain.

Simply put, a Drainage System is one or a group of underground Drain Pipes that take water away from a place that has water standing on it or flowing across it.  The water that is in the problem area, can be causing damage or may be inconvenient or both.  (Usually Both)  A simple Drainage System is a Drain for the water to enter, a Drain Pipe to move the water away from the Drain, and an Exit Point for the water to be released out of the Drain Pipe.

Drainage Systems quickly can become more complicated.  Considerations must include:

How does the water get to the problem area?  There may be one or many sources.

Water Sources:

1.  It falls from the sky directly

2.  It flows down hill over the surface (surface water)

3.  It flows underground under the surface (sub-surface water)

4.  It flows from the edge of a roof ( There may be many roofs near the problem area, neighbors etc.)

5.  It flows from a gutter downspout

6.  It flows over the edge of a gutter because the gutter is too small is is clogged

7.  It flows up from the ground (seeps and springs are common in Oklahoma)

8.  It flows from a sprinkler system use ( yours or your neighbors)

9.  It flows from a leaking pipe ( water mains, water meters, water lines, sprinkler pipes, sprinkler valves)

There are other reasons for Drainage Problems, the above reasons are just the most common.

Once the number of water sources is determined, a rough estimate of the amount of water that needs to be drained away on average must be estimated.  This can be simplified down to “SMALL, MEDIUM, OR LARGE AMOUNTS OF WATER TO BE DRAINED AWAY.  You don’t have to be an engineer trying to calculate fluid dynamics.  Experience at diagnosing drainage problems helps however.  How much water needs to be moved will help determine the type and size of the Surface Drain or French Drain that needs to be installed.  It also helps to determine the size of Drain Pipe required for the Drainage System.  A good rule to follow is, “If in doubt, install a larger Drain and Drain Pipe.”  Unused Drainage Capacity is better than property damage caused by a Drain that is overwhelmed by too much water.

For home and small business use typical materials used are:

6 inch, 9 inch, and 12 inch Surface Drains

3 inch, 4 inch, and 6 inch Drain Pipes

3 inch, 4 inch, and 6 inch French Drains

French Drains move more water than Surface Drains —

French Drains move Surface Water and Sub-Surface Water

Surface Drains move Surface Water only

Surface Drains look nicer than French Drains in most cases

Once the type and number of drains is determined and what size Drain Pipe will connect them, an exit point must be selected.  (Where is the Drainage System going to take the water to and release it?)

The Drainage Curb Fitting is installed when the desired exit point for the French Drain will release the Drainage Water into the Street.   The Drainage Curb Fitting is rectangular in shape and made to be installed through the curb.  A small section of Curb is cut out with a concrete saw.  The Section is a few inches wider than the Drainage Curb Fitting.  We then install new concrete around the curb fitting.  Once the concrete has dried, the Drain Pipe coming from a French Drain or Surface Drain is connected to the Drainage Curb fitting and then covered with dirt.

The Drainage Pop-Up Emitter is connected to the end of a Drain Pipe.  It is downhill from a French Drain or a Surface Drain.  It is a small release basin with a green pop-up lid.  When releasing water, it pops up about an inch to release the water from the French Drain or Surface Drain.  When the Storm Water has moved through the Drainage System and out of the Pop-Up Emitter, the green lid closes back to its original closed position.  The emitter is designed to release water out into a yard or down a hill or other desirable Drainage Exit Point where there is no curb.

Popup Emitter to release water from a Drainage System in Yukon.
Popup Emitter to release water from a Drainage System in Yukon.

Drainage System installation and design is a big part of our business.  Does your sidewalk turn into a moat after a hard rain?  Does part of your yard look like a pond after a thunderstorm?  Worst of all, are you experiencing concrete deterioration to your foundation, sidewalk, or driveway.  We can design a Drainage System to solve your Drainage Problems Our Drainage Systems can be simple or complex.  We utilize, French Drains, Surface Drains, Channel Drains, Basin Drains, Basement Drains, Trench Drains, and Sump Pumps.  Estimates are free!

French Drain Installation In Yukon

Oklahoma Drainage and Sprinkler Repair : Servicing all of Central and Western Oklahoma since 1993.

Standing Water on Your Driveway?  A Surface Drain set in concrete may be what you need. Or maybe you need a French Drain Running alongside your driveway instead.  Handling water problems is what we are good at.  If you need help, Oklahoma Drainage can provide the best solution for your unwanted water problems.

In the Above picture, we installed a French Drain under the left edge of the pool walkway.  The Drain PIpe From the French Drain runs perpendicular from left to right under the walk way stones.  Check out the pictures below.

Installing french drain

Installing French Drain Under Walkway

French Drain walkway

French Drain Installation under walkway

DSC00557

Drainage System Installation

 

Heavy rain went through central Oklahoma last night.  Many Oklahomans have homes or businesses that don’t Drain very well.  Water stands on sidewalks and driveways Storm-water runoff turns yards into ponds.  Water can damage foundations, driveways and sidewalks.  Standing water doesn’t do trees, grass or plants any good either!  Good drainage is important.  If you have water in the wrong place give us a call.  We utilize many types of Drains when designing a Drainage System WE install: French Drains, Channel Drains, Basin Drains, Trench Drains, Basement Drains, Surface Drains, and Sump Pumps.

Give us a call for a free estimate if you live in Central Oklahoma.

 

 

 

 

French Drain Pipe running to curb outlet in Oklahoma City.

French Drain Pipe running to curb outlet in Oklahoma City.

 

Oklahoma Drainage and Sprinkler Repair Services all of Central Oklahoma including: Norman, Moore, Edmond, Yukon, Mustang, Oklahoma City, Midwest City, Del City, Blanchard, Newcastle, Purcell and Chickasha.

 

 

Sprinkler Repair usually occurs in the Spring. WE can help with: Broken Sprinkler Heads, Leaking or stuck sprinkler valves, broken Sprinkler Pipes, Sprinkler Controller/Clock problems,  plus any other sprinkler system problem you might have.

 

 

4 Inch Drain Pipe Ready to be covered with dirt in Norman.
4 Inch Drain Pipe Ready to be covered with dirt in Norman.
Comments
  1. […] out of the basin through a Drain Pipe.  The Storm-Water continues downhill in an underground Drain Pipe to an exit […]

  2. […] may come in many different shapes or sizes.  It is a Drain Basin with a Drain Grate on top and a Drain Pipe connected on the side.  The Drain Grate may be round or […]

  3. Oliver Cordes says:

    Great job! Nice guy, same day repair at a fair price. Thanks Blane!

Thank you for your comments.

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.